View Full Version : Lapper Center punch
kenjuudo
02-19-2009, 10:36 AM
For those that have a hard time drilling boolits on center for lappers, this $4.99 wonder can be found in most hardware stores. Simply hold it in the sprue plate hole and give it a light tap with a hammer.
11563
jim
Bret4207
02-19-2009, 07:50 PM
I don't mean to rain on your parade, but the sprue holes aren't always centered.
fatnhappy
02-19-2009, 08:33 PM
Thanks for the tip Jim.
kenjuudo
02-19-2009, 08:52 PM
Bret, you're right, if they are far off then it's back to the Vee on the combination square and a scribe.
Most of the time the sprue plate can be filed a few strokes and bring them very close to center. I Leemented five six cavity Lees today and only had two that needed a touchup for this. On the rare occasion the holes are off along the axis of the mold faces you are helpless.
jim
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.