Weaver K4 reticle

[sukivel]

I recently got a Belgian 1935 Mauser in 30-06 with a Weaver K4-C3 scope on it. It’s the post reticle.

My question is do you sight the top of the post in at 100, and the idea is the crosshair is like a bdc at 200? In the scope the post is actually a little higher than in this photo. I can’t really find much information about the reticles.

https://uploads.tapatalk-cdn.com/20240206/e14c4b1525f7190392a4b96b92505db9.jpg


Sent from my iPhone using Tapatalk

[Bad Ass Wallace]

I have a number of scopes with post reticule. I sight my Mauser 98 30.06 with the horizontal wire on zero at 100yds and the top of the post is 1.5 inches high for a 200yard zero.

[cwtebay]

My first scoped rifle was a 270 with the same scope / reticle. Crosshairs were set for 300, top of the post 100.

Sent from my Pixel 5 using Tapatalk

[Larry Gibson]

I think you'll find with an older factory velocity level 180 gr load in the 30-06 (2500+ fps) rifle with that K4 reticle top of the post zeroed at 100 yards the crosshair is then close to zero at 300 yards. With whatever jacketed load you're using I'd zero the crosshair at 200 yards and then just use the top of the post for what it ends up at.

With cast bullets, I'd do a visual measurement with a grid target at 100 yards to find out the exact moa between the top of the post and the crosshair. Knowing that you can then decide on a sero based on the cast bullet load and the ranges to be used at.

[HWooldridge]

I love post reticle scopes and have several - I grew up using them almost exclusively. I rely on the post tip to sight in at whatever the desired range is, then determine where the group hits using the crosshairs. Results vary (of course) depending on the cartridge and rifle.

[sukivel]

Thanks guys, those were the thoughts I was looking for.


Sent from my iPhone using Tapatalk

[stubshaft]

I've always mounted my post reticle scopes upside down. That enables me to hold over at long range without the reticle blocking out the animal.