What mold for this ?

[Wolfdog91]

Slugged my Mauser and .....what mold yall reckon I should get ?would really like someone under 190 or 180gr with a HP
https://uploads.tapatalk-cdn.com/20240111/5d384038adec03b8643392fe334e33c3.jpghttps://uploads.tapatalk-cdn.com/20240112/7a627dfe3e54a131ec16b5d7883a57e3.jpghttps://uploads.tapatalk-cdn.com/20240112/5512c4b5c8095690948286b982307df4.jpg

Sent from my motorola edge 5G UW (2021) using Tapatalk

[Texas Gun]

lee C324-175 1R Double Cavity Mold is what i use in my 8mm mauser and this one RCBS 2-Cavity Bullet Mold 32-170-FN 32 Caliber (321 Diameter) 170 Grain Flat Nose Gas Check the one i have it cast at .3235

[Bigslug]

Accurate 32-175M looks about perfect. You could request an as-cast shank of .323-.324", and the leave the nose section as-blueprinted at .311 to bore-ride. The 32-175N is very similar with a larger meplat. If you think the rifle is a fussy feeder, go for the smaller nose.