Missouri Bullet Co

[wallacem]

I jut ordered and received four different cast bullets from this company. They were coated, and will be giving a report on them shortly. The big deal with them was they were able to give me special sizing on them. Wallacem

[cwtebay]

I have bought from them before, excellent consistency and I had good results.

Sent from my Pixel 5 using Tapatalk

[dannyd]

Good company ordered over 20,000 bullets from them, good quality both Hi-Tek coated and regular lube.

[ioon44]

Bullets I have seen from Missouri bullet co have been very poor quality, I would not buy anything from them.

[1006]

I had good luck with 500 of their coated 165 grain 30/30 bullets—fired from a Winchester 94AE. I kept them between 1000-1100fps. At higher velocities, the barrel started collecting the coating.

[cwtebay]

Bullets I have seen from Missouri bullet co have been very poor quality, I would not buy anything from them.Would you mind expounding on the "poor quality" statement?

Sent from my Pixel 5 using Tapatalk

[Bill Allen]

Same company diferent results, can happen. I've loaded some of their stuff although I normally use better bullets since their 10 minutes away never had a problem that wasn't my fault. Got them in a trade

[georgerkahn]

I jut ordered and received four different cast bullets from this company. They were coated, and will be giving a report on them shortly. The big deal with them was they were able to give me special sizing on them. Wallacem

YES! I was in need/want ;) for some over-sized (re sizers I had not nor a mould to cast them in) so I took a gamble on ordering from Missouri. This was a few years back. Anyhoos -- the only not-great was the "wait" until the bullets finally arrived here. If I recall, almost six months! However, each and every bullet sent was, in those words of Mary Poppins, "almost perfect in every way". And... to my Starret indicator, right on to ordered size! I cast/lub/size pretty much all my ammo, but if I should ever get into a need with buying from them as opposed to my purchasing say, a mould + all for perhaps a short-time need -- I'd not hesitate a Milli-second before ordering from them again! (Worth the wait!)
geo

[recumbent]

I have used Missouri bullets for years and have never had a bad bullet.

[Kosh75287]

I've been using Missouri Bullets for over a decade and I've never had less than excellent results from any purchase I made.

[stubshaft]

I have used their bullets for many years and have never had a bad batch of them.

[brassrat]

I made several orders, years back with no problems. They got me going so sentimental.

[Billwelsh]

I had good luck with 500 of their coated 165 grain 30/30 bullets—fired from a Winchester 94AE. I kept them between 1000-1100fps. At higher velocities, the barrel started collecting the coating.

Would you be willing to share your load data for the 165’s. I bought a box but can’t find any data for them.

[Pereira]

I've bought and shot a Lot of their products, and never had an issue.
In fact there are a few thousand over there under the bench right now.

RP