P - C bullet mold [Archive]

midnight

10-04-2023, 10:44 AM

I recently obtained an aluminum two cavity mold for a 220gr SWC bullet for the 41 Mag. I bought it because it was stamped with a maker I have never seen before & there are over 260 molds down in my basement. The maker stamp reads “ P - C. Have any of you ever seen this. It appears to be of good quality and resembles the work of NEI.

Bob

Green Frog

10-04-2023, 11:22 AM

Good question. Why not post this under “Mold-Maintenance and Design” wher the mould discussions take place?

leadhead

10-04-2023, 12:14 PM

Can you put up a pix of it?

slim1836

10-06-2023, 12:01 PM

Could it perhaps have been made by Arsenal? Some of their molds are marked PC.

Slim

tinsnips

10-08-2023, 08:28 PM

Could in mean powder coat?

gwpercle

10-09-2023, 12:40 PM

Could in mean powder coat?

My thoughts exactly ... but Powder Coat would be too easy an answer !

But .... If that mould is smooth sided and only has a crimp groove ...
...then Maybe we got something :CastBoolitsisbest: !
Gary