View Full Version : .365 Sizing Die
Divil
07-17-2023, 07:40 PM
I now have a 9x18 Makarov and dies. Brass is coming later this summer or fall. Does anyone make a .365 inch sizing die?
Greetings,
Lee markets a 0.365" die.
https://www.leeprecision.com/bullet-szr-punch-365
It is the new design and I believe you need a holder for it.
Cheers,
Dave
Divil
07-17-2023, 09:49 PM
Thanks. The holder I have. I could go the tumble lube route.
However, doesn’t anyone make a .365 sizer to fit a Lyman Lube Sizer?
flatnose
07-18-2023, 03:20 AM
Thanks. The holder I have. I could go the tumble lube route.
However, doesn’t anyone make a .365 sizer to fit a Lyman Lube Sizer?
I have purchased custom sizing dies from Buffalo Arms. They can probably make it.
Divil
07-18-2023, 02:03 PM
A check of their website shows this item to be in stock. Thanks!
vikingsword7
07-18-2023, 09:34 PM
I just recently started casting for my Makarov and the mold kicks out a .365,366 nugget which I planned on powder coating. I Had a Lyman .359 which I reamed and polished out to .363 which I used to size them down, then I powder coated them, they then measured .365+. I then ordered a push thru sizer at .365 and they came out perfect as my bore slugged out at .363.5 .
leadhead
07-19-2023, 03:26 PM
I have a Lyman .366 diameter die that I don't remember where I got it, but Lyman made them
a long time ago. Don't know if they still make that size or not. It's perfect for the 9x18 Mak.
kywoodwrkr
07-19-2023, 04:56 PM
C.I.P. shows many 9.3 cartridges in both rimmed and rimless rifle category. .366" = 9.295238095238095mm .
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.