PC hollow points

[Longcarbine]

Is there any place out there that sells powder coated hollow point handgun bullets. Or some place that would powder coat my bullets.

[GregLaROCHE]

Consider doing it yourself. It’s not that hard and doesn’t cost much to get started in, especially if you can find a small oven in a thrift shop. I don’t find PCing hollow points more difficult than normal boolits. If you do get a bit of powder in the hollow point, it won’t make a big difference.

[T.J.Smith]

It's very easy to do........just get a good mold & try it. It can be a lot of fun.
317339

[atfsux]

https://sscastbullets.com/product/357-38-hp-pb-gas-check-hi-tek/

Straight Shooters Cast Bullet Company in West Virginia. They make a perfect bullet for duplicating the .38spl. 158grn. LSWCHP "FBI load", using pure plain lead with a Brinell hardness number of only 5 in order to ensure opening up at snubnose sub-1000 fps velocities, baked with Hi-Tek and given a gas check.

[firefly1957]

LongCarbine Try enamel spray paint and bake them 30 minutes at 400 degrees in a oven that will never be used for food .
The bullets must be rinsed with acetone before spraying , I have driven soft lead over 2100 f/s this way in rifles and 1700 in 10" contender.