huntinlever
06-07-2023, 06:28 PM
O-Rings on my LAM plunger are shot, getting as much splooging above the plunger and into the bullet grooves. Not finding much by way of replacement parts for the LAM. Need either the o-rings or a new plunger. Suggestions?
(Also, dumb question - but I ran several bullets through and couldn't figure out why they weren't looking well-lubed as they always do. Now I know. Once I get the part(s) replaced, can I just run these again, or should I remove the lube and start over?)
(Also, dumb question - but I ran several bullets through and couldn't figure out why they weren't looking well-lubed as they always do. Now I know. Once I get the part(s) replaced, can I just run these again, or should I remove the lube and start over?)