Lyman Sizing Die O-rings

[dabrown56]

Who can tell me the size of O-ring OR, where to get them for Lyman Sizing Dies.

Thanks

[BLAHUT]

Harbor freight has bulk O-rings, you can match them up with what you have.

[andy h]

Pressure nut - #16, 13/16 x 1-1/16 x 1/8
Die - #35, 9/16 x 11/16 x 1/16

[Winger Ed.]

Not as cheap as the hardware store, but if you call Lyman they'll sell 'em to you--- and you don't have to drive into town to get them.

[farmbif]

for bags of 100 and a huge variety of different material such as viton, butyl, ect. mscdirect is where I order orings. its saved me $100s compared to buying from hydraulic suppliers

[hc18flyer]

Most Ace Hardware and farm stores should have them. I carry in my old ones and match them up. hc18flyer

[Rich/WIS]

Think I got mine at Ace, but any well stocked hardware outlet should have them. The brand on mine is DANCO and are labeled #35. They come 10 to pack. If you can't find them locally PM me your address and I'll send you a couple.

[Scrounge]

Who can tell me the size of O-ring OR, where to get them for Lyman Sizing Dies.

Thanks

I bought mine from Ebay. Brownell's also carries them. They are not one of the usual stock sizes. I've got both metric and SAE o-ring sets, and nothing I had fit them properly. Though I see others say otherwise. Some of my sets are quite old, and been picked over for years. YMMV!

Bill

[uscra112]

McMaster-Carr, if all else fails. They'll have the right size, and you'll get 'em in less than 48 hours, but that shipping is expensive.

[gwpercle]

Not as cheap as the hardware store, but if you call Lyman they'll sell 'em to you--- and you don't have to drive into town to get them.

:goodpost:
LIKE

[andy h]

Late reply both LYMAN and RCBS sizing die's use US standard AS568 no 015 orings 9/16 x 11/16 x 1/16 70 shore/Durometer ,Mc Master part number 9452k59 $5-43 per 100 , Hope this helps.

[dabrown56]

Late reply both LYMAN and RCBS sizing die's use US standard AS568 no 015 orings 9/16 x 11/16 x 1/16 70 shore/Durometer.This is what I have been looking for, thanks!