My casting bench

[dakotashooter2]

My casting bench. Steel cabinet with stainless steel top with sink. Left side is storage for ingots and molds. I fill the sink with water and set a preforated plastic bucket in it for water dropping bullets. Mounted a vent fan assembly above the pot and vent itout the window. :castmine:

http://i50.photobucket.com/albums/f329/dakotashooter2/P1010034-1.jpg


http://i50.photobucket.com/albums/f329/dakotashooter2/P1010035-1.jpg

[uncledeck]

Real nice setup.

My only comment is since each shelf may be large enough to hold 300-400lbs of ingots you may need to reinforce the shelf or the cabinet as you add more ingots.

I wish my setup was as nice. Thanks for sharing

[docone31]

I should be so lucky!
I start out with a pristine area. I turn it into lower slobovia in an heartbeat.
I like the stainless top.

[dakotashooter2]

Actually I try to keep the weight around the edges of the shelves where the most support is and store lighter objects in the center of the shelves. I also like the fact that the stainless top has a bit of a lip to contain spills.

[jdgabbard]

I need to find something like that only about 2' x 1 2/3' x 3' for my bedroom reloading bench at my Apartment. I've got a whole garage with a full size bench at my Cabin. And a nice setup on it. But spend most of my time at the Apt. Something like that but with a wooden top would be perfect!