Testing, testing, 1,2,3

[Nightwing_Actual]

This thing on?

I am just starting to get setup for my first attempt at bullet casting. Been buying blue bullets for a long time but I’ve had about 50 pounds of lead ingots under the bench for about 4 years. Finally time to try it out.

I picked up a couple of Lyman and lee molds off Reddit recently, is there somewhere I can post where I can get help identifying them? Secondly if I can’t use some of them what’s the process I need to follow in order to trade/ sell them so I can get something I can use?

Appreciate the help

[Sasquatch-1]

Welcome to the site. For ID'ing your molds go to the equipment sub-forum. As far as trading or selling on the site, there is a sticky at the beginning of the Swapping and Selling section that explains the rules.

[William Yanda]

For the Lee molds, compare what you have to the Lee catalog.
What caliber and purpose are you looking to reload for?
Bill

[Nightwing_Actual]

It looks like the lee molds are for black powder, one is a .45 cal 200gn other is a .50 cal 250gn.

I am looking to make .45 (acp and LC) .455 webley, 9mm, .357 mag, and 30-30.