Lee APP slide stop

[Multra]

Created a part to control how far back the grabbing slide goes on the Lee APP to improve the reliability of the case feeder. I found that if the slide goes back slightly too far it causes case to not feed into the die area very well. You can control this by setting the die depth, but that solution doesn't work too well when you are doing things like swaging primer pockets as there is no die. https://www.thingiverse.com/thing:5646765

[Handloader109]

Good idea, I do think that has been an issue for me too. I didn't think of a stop. Thanks, will give it a try

Sent from my SM-S908U using Tapatalk