tja6435
11-12-2022, 07:12 PM
I recently got back into casting after a move and a house build.
I found this 9mm boolit mold made by Hardline Industries in my (several) buckets of molds. I now recall why I like this boolit so much. Has the same form as a 115gr fmj bullet and just drops from the mold like cold butter off a hot knife.
Too bad Hardline isn’t still around, I have 5-6 other molds of theirs; all run great but I really, really like this one.
306806
What’s crazy is this Hardline mold is iron, but it weighs less than a brass mold from NOE or MP. Much easier on my wrist and elbow. I just ordered a new toaster oven and dug out my Hi-Tek coating so I can load these beauties up.
I found this 9mm boolit mold made by Hardline Industries in my (several) buckets of molds. I now recall why I like this boolit so much. Has the same form as a 115gr fmj bullet and just drops from the mold like cold butter off a hot knife.
Too bad Hardline isn’t still around, I have 5-6 other molds of theirs; all run great but I really, really like this one.
306806
What’s crazy is this Hardline mold is iron, but it weighs less than a brass mold from NOE or MP. Much easier on my wrist and elbow. I just ordered a new toaster oven and dug out my Hi-Tek coating so I can load these beauties up.