harringtondav
11-11-2022, 02:27 PM
I found this sight in my dad's reloading trunk. I Googled the patent number and found that it is from a Martini Cadet rifle.
Interesting because I remember him owning a Cadet. The base of the sight has a machined radius apparently to fit on the receiver or barrel.
My question is about the longitudinal convex radius along the length of the sight. ....Is this normal?
The sight is a bit knackered up, so I was wonder if it was bent during removal.
Thanks, Dave
306711
306712
Interesting because I remember him owning a Cadet. The base of the sight has a machined radius apparently to fit on the receiver or barrel.
My question is about the longitudinal convex radius along the length of the sight. ....Is this normal?
The sight is a bit knackered up, so I was wonder if it was bent during removal.
Thanks, Dave
306711
306712