nvreloader
10-24-2022, 07:06 PM
Well guys
I like some help/information about the 2 new (to me) lube sizers,
both came with NO top punch and dies.
1. Is a Cramer Brand name (North Hollywood Ca), it has a cap headed Allen screw that holds the die in? Die flange hole is .875" dia by .100" deep with a .780" die body hole and is approx. 1.600" long and has a .655" exit hole at the bottom of the die casting holder.
The top punch hole is threaded (unknown size yet) and is approx, .250"? in dia and is threaded with a tapered cone at the bottom of the threaded section.
There is a threaded screw for table clamping and or the 2 bolt down holding method, and is left handed operation, which I'll change, if it works for my pellet sizing press.
2. Is a Saeco Brand (Carpinteria Ca), this press almost looks like the Cramer press list above, with a die body hole of .785" dia with a casting body length of 1.330" long and end in a .675" dia hole.
The top punch hole is threaded (unknown size yet) and is approx, .275"? in dia and is threaded with a tapered cone at the bottom of the threaded section. This press is also left handed operation, and has the 2 bolt hold down method.
I am going thru the casting tool section, (pg 10, so far) and I have not found any information on either of these press's.
I can see the Cramer hold the sizing die in via the cap screw, but I think the Saeco works the same as my OLD Herters sizer, it has a nut that holds the die in?
I need to know the top punch thread diameter and if it possible to find a sizing die for both of them? So I can make a die body for pellet sizing etc.
Any and all information would be greatly appreciated.
Thanks in advance,
Don
I like some help/information about the 2 new (to me) lube sizers,
both came with NO top punch and dies.
1. Is a Cramer Brand name (North Hollywood Ca), it has a cap headed Allen screw that holds the die in? Die flange hole is .875" dia by .100" deep with a .780" die body hole and is approx. 1.600" long and has a .655" exit hole at the bottom of the die casting holder.
The top punch hole is threaded (unknown size yet) and is approx, .250"? in dia and is threaded with a tapered cone at the bottom of the threaded section.
There is a threaded screw for table clamping and or the 2 bolt down holding method, and is left handed operation, which I'll change, if it works for my pellet sizing press.
2. Is a Saeco Brand (Carpinteria Ca), this press almost looks like the Cramer press list above, with a die body hole of .785" dia with a casting body length of 1.330" long and end in a .675" dia hole.
The top punch hole is threaded (unknown size yet) and is approx, .275"? in dia and is threaded with a tapered cone at the bottom of the threaded section. This press is also left handed operation, and has the 2 bolt hold down method.
I am going thru the casting tool section, (pg 10, so far) and I have not found any information on either of these press's.
I can see the Cramer hold the sizing die in via the cap screw, but I think the Saeco works the same as my OLD Herters sizer, it has a nut that holds the die in?
I need to know the top punch thread diameter and if it possible to find a sizing die for both of them? So I can make a die body for pellet sizing etc.
Any and all information would be greatly appreciated.
Thanks in advance,
Don