Mp 359-125

[Michael J. Spangler]

Hello

I was hoping someone had the dimensions for this one?
I would like to order one because I’m thinning it will work well in my tight throated CZ
I’m currently using the 360-130 2R which is a great mould but it’s a little chubby.

I’m thinking the 359-125 has a “bore riding” look to it and might chamber better without having to deep seat it.

Thank you!

[44Blam]

I've got this mold:
MP 357-125 HP PB 4 Cavity NO LUBE GROOVE mold

It's a magic mold. First session started casting good boolits from the start. They end up weighing about 133-134 with the penta-point.

305750

I shoot them in my Springfield Heckcat and they shoot great.

[Michael J. Spangler]

Can you tell me the diameter of the bullet right where it steps down to the “bore ride” area please?

[44Blam]

Can you tell me the diameter of the bullet right where it steps down to the “bore ride” area please?

I coated mine with two coats of hi-tek and I am getting .3495-.350".

[Mal Paso]

Can you tell me the diameter of the bullet right where it steps down to the “bore ride” area please?

On the 359-125 cast in WW+ tin .353"

[Michael J. Spangler]

Thank you!