Custom shop suggestions to get my gen 4 glock 20 milled for a deltapoint pro

[Tripplebeards]

I would like to get my gen 4 Glock 20 milled for a deltapoint pro. I already have the sight and just need to get the slide milled. Wondering who does a good job. Also wondering if I could buy a slide already milled for close to the same price? The place I bought the 20 from was out of 40’s or I would have probably bought one and not have to jump through hoops.

[BK7saum]

I have used mapleleaf firearms in Celina Tx. They did a fabulous job on my G19 amd G43x for Trijicon RMR.

I am sure they have a CNC program for the deltapoint as well. They can return the slide with the raw cut, or you can gave it nitrided. I think they also offer a paint of the cut only to prevent corrosion.

Everyone I know that has used them has been satisfied.

[BK7saum]

https://www.mapleleaffirearms.com/

[Tripplebeards]

I see there’s a $60 or more upgrade just about anywhere I look to put a finish on it. I am debating on Oxpho bluing where it’s milled to save some money. I am confident in my bluing.

[megasupermagnum]

One that is semi close to you that does really nice machining work is Ahlman's gunsmithing in Morristown, MN.

[Wayne Dobbs]

I'm in the red dot sight business full time (that Swedish company) and I'd highly recommend Jeremy Daugherty/Vulcan Machinewerks, Plano, TX. There are lots of vendors for these services out there, but I've seen lots of his work and have extreme confidence in him. https://vulcanmachinewerks.com