DanOH
01-24-2009, 04:58 PM
Was sizing some bullets and thought the sizer had ran out of lube a little sooner
than it should have.
When I went to add lube there was a good 1 1/2 inch of lube above the plunger.
The O-ring was in shreads up in the lube.
I had been using LARS c-red so I may have started cranking on the handle before
the lube had softened w/heat.
Is the o ring a standard size that I could pick up locally (what size?) or should i get a replacement from RCBS?
thanks
Dan
than it should have.
When I went to add lube there was a good 1 1/2 inch of lube above the plunger.
The O-ring was in shreads up in the lube.
I had been using LARS c-red so I may have started cranking on the handle before
the lube had softened w/heat.
Is the o ring a standard size that I could pick up locally (what size?) or should i get a replacement from RCBS?
thanks
Dan