223 electric case feeder for app press

[Jim P.]

I have made an electric case feeder for feeding 223 cases on a Lee app press. I was thinking about selling these on ebay and was just wondering if there would be any interest in these. I havnt tested it but i bet it would feed other calipers of rifle cases also.

[Winger Ed.]

Way cool.

I'd make a few and market them like that.
It might not make you rich, but I can see making a few bucks with it.

It's one of those things that if it sells real well, the big guys will get in the market with a cheap Chinese one to 'help ya out'.

[ddeck22]

There is one on Thingverse that a lot of people have built. I would ask how is this one better than the one people can print themselves? Or are you offering it as a printing service?

[Loudy13]

I would be interested in a bullet feeder if you decide to make them.

[Jim P.]

Most but maybe not all only feed pistol cases. This feeds tall rifle cases and this is a little bigger than most of those. I printed one of the thingiverse ones but it wont hold many rifle cases. Also the ones on thingiverse dont have a good way to use the inductive sensor to shut off the motor when the feed tube is full. Plus all wires except the power cord and the wire going to the inductive sensor are inside the box that houses the relay and the motor and the power switch.

[IllinoisCoyoteHunter]

+1 on the bullet feeder

[taylorce1]

I don't post much here, but I'm interested in a case feeder. I'd really like it if it was expandable to pistol and larger rifle cases than just .223 sizes. I would also be interested in a bullet feeder as well when I upgrade to a progressive press.

[chambers]

Video and price point?

[Jim P.]

Im working on a video and also plates for large rifle and also pistol cases.

[huntnman]

Would like to follow thread, have interest.