Subsonic 350 Legend Powder coat

[richbug]

Looking at an Accurate 36-260p mold to make best use of a suppressor I am waiting on. Figure I can use the wait to make some ammo. Rifles are a Ruger American ranch and and AR, both have 1 in 16 barrels.

Online stability calculators say this bullet should be plenty stable.

plan is to shake and bake PC. Probably start with 4227 powder and see where that leads me.

Anyone been down this road yet? Any other molds I should look at?

[BK7saum]

I didnt look up the boolit, but if a bore rider, it may be too wide after PC to chamber.

[richbug]

I didnt look up the boolit, but if a bore rider, it may be too wide after PC to chamber.

Smooth sided paper patch design with a rounded flat point. Not a bore rider. I would size accordingly and seat to fit my throats.

[mehavey]

Metplat of (0.18") may freed.
That of the 36-270CG (0.24") will not.
(Ask me how I know :twisted: )