To cold to cast bullets today

[catkiller45]

Last I looked it was minus 12 here. My casting shed is just to damn cold.lol

[dannyd]

Raining here today but going to 56 tomorrow, so I will be casting tomorrow.

[country gent]

NAw CatKiller45 you just need to get bigger pot to cast from

[Outer Rondacker]

I feel your pain. Been that way all month here. Just to cold.

[lightman]

-12 would be too cold for me too! Winter will be over, sooner or later.

[Alstep]

-6 here. I cast in the cellar next to my coal stove. Hang a pot in the stove and all the fumes from smelting go up the chimney. Then pour into my PID controlled electric pot have have at it. Nice & warm.

[Beagle333]

I'm huddled indoors at only 35° today. But fortunately I have a big pile of already cast boolits. Spring isn't far away. Hang in there!!

[centershot]

Yup, pretty cool here too, +1.6*F. I've got plenty of boolits in my stockpile, so no worries there!

You guys in the colder ares, take a look at this:

https://www.lowes.com/pd/Avenger-Avenger-Infra-Red-Tank-Top-Propane-Heater-Single-Burner-15-000-BTU/5001199635?cm_mmc=shp-_-c-_-prd-_-sol-_-bng-_-PLA_SOL_237_Seasonal-Heat-Coolers-_-5001199635-_-Online-_-0-_-0&ds_rl=1286981&msclkid=6c45f94fe7961783dbcf98a266c1aeb3&gclid=6c45f94fe7961783dbcf98a266c1aeb3&gclsrc=3p.ds

I bought one of these some years back, works pretty good! I cast in what was a garden shed about 6' x 8'. Even on low, this thing supplies all the heat I need to cast in winter.

[Dom]

Yup, pretty cool here too, +1.6*F. I've got plenty of boolits in my stockpile, so no worries there!

You guys in the colder ares, take a look at this:

https://www.lowes.com/pd/Avenger-Avenger-Infra-Red-Tank-Top-Propane-Heater-Single-Burner-15-000-BTU/5001199635?cm_mmc=shp-_-c-_-prd-_-sol-_-bng-_-PLA_SOL_237_Seasonal-Heat-Coolers-_-5001199635-_-Online-_-0-_-0&ds_rl=1286981&msclkid=6c45f94fe7961783dbcf98a266c1aeb3&gclid=6c45f94fe7961783dbcf98a266c1aeb3&gclsrc=3p.ds

I bought one of these some years back, works pretty good! I cast in what was a garden shed about 6' x 8'. Even on low, this thing supplies all the heat I need to cast in winter.

Yes, I have had one of those propane heaters for years.They flat out work.

[Winger Ed.]

There is hope.
Every day--- We're getting closer to Summer, not farther away from it.

[dannyd]

Using what cool weather we are going to get. About 60 degrees :)
295084

[GregLaROCHE]

I can dress up and do some as long as there’s not a lot of wind. In the summer I usually stop because my wrist gets tired. When it is cold, it’s always my cold feet that force me to stop. I wish I still had a pair of bunny boots, even if just for casting.

[GregLaROCHE]

I can dress up and do some as long as there’s not a lot of wind. In the summer I usually stop because my wrist gets tired. When it is cold, it’s always my cold feet that force me to stop. I wish I still had a pair of bunny boots, even if just for casting.

[Sam Sackett]

My garage was a tad cool, but I stayed with it. Ended up casting about a few hundred 158 grain RF for the 38/357 and some 230 grain 45’s.



Sam Sackett

[Larry Gibson]

Using what cool weather we are going to get. About 60 degrees :)
295084

Me too, here in the Arizona desert "cool" is relative. Got down to 50 this morning so I headed to my casting table and cast up 1000+ 45 ACP bullets before it got up to 68........

[Dancing Bear]

Too cold to cast here too, but a few years ago when my Lee Bator 6 cavity mold arrived around this time I did go out to do some casting. Took a long while to get that mold up to casting temperature!

[rintinglen]

I've just got a new Accurate mold, and my birthday purchase from NOE is still waiting from last month. It has to be at least 50 before it is casting weather in my garage. Looks like they'll be waiting for next month, though today was pretty nice.

[Jack Stanley]

The dungeon was a pleasant 65 even with the exhaust fan running full out .

Jack