Hornady case feeder

[cheese1566]

Hornady case feeder from jsondag on thingiverse.com.
Used PLA, Cura superior settings and most parts varied from 25-40% fill for strength. Didn’t use any glue, but added a steel cross bar on the top from the primer arm for rigidity. Already had some 5/8” clear PETG tube from the Green Machine project. Works great so far for 9mm. Just need a small length of Lee 9/16” tubing to adapt it up for 38’s and 223. His design uses a Lee style case feeder, simple enough for my slow loading needs.

293091293092293093


https://www.thingiverse.com/thing:2488944

[ddeck22]

I built that one and added the rotating adapter at the bottom like this one (their version 2): https://www.thingiverse.com/thing:4893734

That way, you don't need to have different tubing adapters above the top slider. All I did was mirror the top part and flip it and make different size tubes. I have one that is for 45, 38 special, 9 mm and 40. I think you could get away with the 40 and 9 being the same.