6mm round nose 112 grain questions.

[cwtebay]

Howdy all, I will very shortly run out of my hoard of the bullets in the title. Does anyone know of a forming die that will produce this nose profile? I don't care if it is exposed lead tip or full patch (not necessary to perform as hunting bullets). I have a project coming up early next year, and I have tried every alternative that I can think of and not been able to attain the feeding reliability that is required. Yes, I have cast for it but can't seem to get them to feed either.
Thank you!

Edit: I am an EXTREME novice to swaging - apologies if my questions are basic!
The attached picture is an approximation of what I am looking for.https://uploads.tapatalk-cdn.com/20211017/3bd542d8bf00b03eaba9bf41dccec495.jpg

[deltaenterprizes]

That should be close to the profile of a 6mm ball end mill!