odoh
01-12-2009, 02:10 PM
Picked up an ingot of unkown alloy at the recyling center last week. Its 23#s of mat'l lil' harder than lino using ball/anvil (indent) test. MonoType?
its 25" long
its 2" high
its 2 1/8" wide (bottom)
its 1" wide (top)
Has an elongated open ended tie-down loop at each end.
Has place for a mold number (illegible) and says not to be sold acrossed the tip. I'm not familiar w/babbit but it seems to puddle/melt easily w/benz torch. I've seen a pix of a similar one on ebay once but it too had very lil' info.
Any ideas? I've 25cents a pound invested ~ ~ ~ thots?
its 25" long
its 2" high
its 2 1/8" wide (bottom)
its 1" wide (top)
Has an elongated open ended tie-down loop at each end.
Has place for a mold number (illegible) and says not to be sold acrossed the tip. I'm not familiar w/babbit but it seems to puddle/melt easily w/benz torch. I've seen a pix of a similar one on ebay once but it too had very lil' info.
Any ideas? I've 25cents a pound invested ~ ~ ~ thots?