Remington 07/15 Berthier

[Pressman]

I took the day off yesterday from doing usefull tasks and went to Mankato, for coffee at Caribou and shopping at Scheels. They had almost no used guns, except a near mint Remington Berthier rifle. I looked and fondled, looked, and fondled then decided that a $1000 dollar rifle with no ammo available was not going to make my life better. But darn it was pretty and it felt good to hold and handle.

I had never seen one before. I couldn't figure out how to get a picture in the store.

Scheels ammo shelves were full so a brick of CCI 22's and a less expensive scope followed me home.

Ken

[ascast]

well done, all around. I think you can get basic brass, standard Lebel?

[GregLaROCHE]

I wish I could buy one in that condition and price here in France.

[Adam Helmer]

Pressman,

I assume you bought that 07/15-I would have in a heartbeat. I have several and cannot do much with them due to health issues. Send me a PM and I will discuss 50 rounds of new brass, a set of RCBS dies and my secret reloading data that I cannot use. I have a few 5-round clips that go with the brass and dies. If interested, I will sell the lot to pay for my radiation treatments.

Adam

[Pressman]

Adam, I am sorry, I did not buy it. Not knowing much about it and the asking price was outside of my budget for the month I had to pass. It really is a beautiful rifle.

[ukrifleman]

289622289623289624

I was lucky enough to find a mint, unissued Remington 1907/15 this side of the pond a few years ago.

The only markings on it, is a 2013 Birmingham Proof mark.

ukrifleman

[fgd135]

I've seen several Remington Berthiers for sale over the years, and they seem to be either as nearly new in original military configuration, or conversely, as really beat up sporterised rifles.

[Texas by God]

I remember Springfield Sporters offering Berthier Turkish Forestry carbines at a reasonable price. I didn't get one because 8mm Lebel ammo or brass was practically non - existent in the 1980s. Times are better in the ammo regard nowadays thanks to Privi.

Sent from my SM-A716U using Tapatalk

[Adam Helmer]

Pressman,

Well, that is OK. My brother came by just after my last post and scooped the dies, brass and clips for his 8mm Lebels.

Adam