PDA

View Full Version : BFR Bisley



Iwsbull
07-25-2021, 12:37 AM
I managed to find one in 500 Linebaugh and last week my molds arrived, Tom at Accurate Molds outdid himself again. The bisley grip really tamed the recoil of the modest loads I fired as long as I maintained a fairly snug grip, otherwise it would catch my knuckle slightly but not near as bad as my 44 special with a Ruger Bisley. I will admit it I was not real enamored with the looks until I ran a 100 or so rounds through it and I must confess after seeing/feeling how well it works I now find it one of the most attractive grips I have seen.

blue32
07-26-2021, 07:52 PM
What was the turnaround on that Accurate mold?

Iwsbull
07-26-2021, 08:33 PM
About 10 weeks.

white eagle
07-28-2021, 07:55 PM
that same piece is on my bucket list
\any pics to drool over?

RJM52
07-28-2021, 10:40 PM
Nice...

Was looking at basically the same gun in .500 JRH because I have a lot of .501 bullets for a 4" S&W .500... Bid on a couple but ended up passing on them. Found a Freedom Arms 83 with in .500 Wyoming and an extra cylinder in .500 JRH...with a 4.75" barrel... Only have have had the time to put about 50 rounds through it but has been great so far...like it much better than the .475 Linebaugh I had...

Bob

Iwsbull
07-29-2021, 10:52 PM
The knuckle clearance and the ability to get my whole hand on the grip is nice. It really amazes me every time I shoot it at how well it mitigates the recoil. 286827286828