View Full Version : drying out damp PC
Walter Laich
07-21-2021, 09:53 PM
another thread got me thinking:
how do you go about 'drying' out PC that has been left open in humid garage?
Open inside a house that has A/C for a few days?
lightly heat the powder?
just curious . . .
Conditor22
07-22-2021, 01:14 AM
Open in front of AC works, a dehumidifier works or you could dry it in an oven <140° (if you get lumps, they will be pulverized when you ASBBDT).
jessdigs
07-22-2021, 01:19 AM
Drop dry rice in maybe? Worked for my phone years ago
Sent from my Pixel 4 XL using Tapatalk
imashooter2
07-22-2021, 01:54 AM
I save every silica desiccant packet I find. Store them in glass jars. I would drop a couple in the container and seal it up.
put it in a sealed container with damp rid, calcium chloride sucks moisture out of the air
yeahbub
07-23-2021, 12:51 PM
A cheap source for the calcium chloride is that ice melt stuff. I mistakenly left a bag of it open in the garage and it turned into a wet rock leaking water all over the floor. A very aggressive dehumidifier. It's in a bucket now and nearly full of water. BTW, the fully saturated calcium chloride/water solution is great ice melt stuff too for light ice/snow on steps and porches.
reedap1
07-26-2021, 07:02 PM
I store my powders in glass jars with a rubber liner seal, similar to canning jars/lids. I then store the closed jars in a large MTM plastic ammo can which has a rubber seal and I put a jar of opened silica in the container. The box is then stored in my air conditioned basement where relative humidy hovers around 45%. My powders are completely dry and stick to the bullet very well
Smoke4320
07-30-2021, 12:11 PM
I am betting a a hour or so in texas sun would do the trick.. spread out thin on a pan. Just not on any pan that will magnify the suns heat and not 100 + degrees
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.