View Full Version : GC .30-.30 boolit before or after PC?
Rico1791
06-17-2021, 08:06 PM
I have been searching the forum. Looking for the proper answer. Do I gas check the bullet during the sizing process before powder coat or after?
Sent from my SM-G973U using Tapatalk
Smoke4320
06-17-2021, 08:47 PM
I personally like to gas check before pc.
PC will the lock the check on real good. Then size again after PC.
Doing it this way I have never had check come off in my suppressors
Rico1791
06-17-2021, 08:49 PM
I personally like to gas check before pc.
PC will the lock the check on real good. Then size again after PC.
Doing it this way I have never had check come off in my suppressorsThank you Smoke.
Sent from my SM-G973U using Tapatalk
charlie b
06-17-2021, 10:58 PM
Discussed lots of times.
I like to apply GC before PC. Some of my bullets won't allow a GC to be seated if they are coated first. And, like Smoke said, it 'reinforces' the GC crimp.
A bit tedious, but, I cast, seat the GC, size base, nose size (when needed), powder coat, size nose and size base. Then ready to load. These are rifle bullets with a goal of less than MOA.
Rico1791
06-17-2021, 11:41 PM
Discussed lots of times.
I like to apply GC before PC. Some of my bullets won't allow a GC to be seated if they are coated first. And, like Smoke said, it 'reinforces' the GC crimp.
A bit tedious, but, I cast, seat the GC, size base, nose size (when needed), powder coat, size nose and size base. Then ready to load. These are rifle bullets with a goal of less than MOA.Thank you Charlie B.
Sent from my SM-G973U using Tapatalk
What smoke4320 says.............
Rico1791
06-17-2021, 11:55 PM
What smoke4320 says.............I am beginning to see a pattern.
Sent from my SM-G973U using Tapatalk
FredBuddy
06-18-2021, 10:48 AM
I made an expander tool for the GC
so I can put it on after - I can do it
either way.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.