Johnch
06-02-2021, 01:55 PM
I just finished 2 new 2 gang molds 400 gr GC mold and a 500 gr GC for the 500 S&W
I plan on seeing how Powder Coating works first
I have a 10" 500 S&W BFR revolver and a H&R single shot Rifle
I feel no need to shoot hot loads in either
So I figure I could begin with close to a starting load and work up if I see some need to
As I figure with the right loads I could hunt anything on Earth
It just depends on how bad the recoil needs to be , Before my ego says I have had ENOUGH
I have 2 full - 8 lb jugs of Alliant 2400 plus a little over 2 lb in a third jug , so I can load for a while
Starline Brass
Powder Coated 400 gr GC and 500 gr GC bullets out of range lead about like WW in hardness
What would be a safe Starting loads ?
Thanks
John
I plan on seeing how Powder Coating works first
I have a 10" 500 S&W BFR revolver and a H&R single shot Rifle
I feel no need to shoot hot loads in either
So I figure I could begin with close to a starting load and work up if I see some need to
As I figure with the right loads I could hunt anything on Earth
It just depends on how bad the recoil needs to be , Before my ego says I have had ENOUGH
I have 2 full - 8 lb jugs of Alliant 2400 plus a little over 2 lb in a third jug , so I can load for a while
Starline Brass
Powder Coated 400 gr GC and 500 gr GC bullets out of range lead about like WW in hardness
What would be a safe Starting loads ?
Thanks
John