PDA

View Full Version : Recommended Loading of FA Wet Tumbler



alamogunr
04-07-2021, 02:59 PM
I acquired a Frankfort Arsenal wet tumbling apparatus last fall. At that time I had read somewhere what the estimated loading for various cartridge brass was. I didn't use it over the winter and now I don't remember the est capacity. Does anyone remember where it was posted or have an estimate of that capacity?

I am primarily wanting to clean 9mm, .38 Spec and .45 ACP.

rick benjamin
04-07-2021, 03:24 PM
https://www.frankfordarsenal.com/case-cleaning/case-cleaning-media/platinum-series-rotary-tumbler-7l/909544.html

onelight
04-07-2021, 03:38 PM
I load by the coffee can 1lb8oz for 9mm and smaller and 2lb 5oz for 40 and up , add pins and water a few inches over the cases the large FA tumbler , been doing this a couple of years now . I have no idea what this weighs.
So far so good :)

Norcal707
04-07-2021, 04:40 PM
With the large F.A.R.T., I basically weigh 7lbs of 9mm, 223, etc., add 5lbs of SS pins, a short squirt of Dawn, a couple capfulls of Armor All Wash n Wax, two 40S&W casings of citric acid powder, and fill about 3 inches from full with hot H20. With the 3lb tumbler Drum, total weight is about 24lbs - 6lbs less than the rated maximum load. I think it's probably best not to max the thing out in order to extend the life of the motor, gears, etc.

Eddie17
04-07-2021, 05:12 PM
I’m with one light, coffee can of brass! I add lemishine with armorall car wash and wax.
Brass look bright an clean, after a tumble in the F.A.R.T.