View Full Version : C&H 204 pin
Joe504
02-26-2021, 07:09 PM
Hey peeps, what is this pin called,and where can I get one?
This is for a C&H 204.
Thankshttps://uploads.tapatalk-cdn.com/20210226/cb014e2499bf909c7bb4c0b6a75c4994.jpg
Sent from my SM-G955U using Tapatalk
Mk42gunner
02-26-2021, 08:08 PM
Have you tried the CH4D website? They used to carry parts for most of their older presses.
Robert
shaune509
02-26-2021, 09:56 PM
Take the press to a auto parts, motor shop and get an alignment pin to fit the dia. You will probably need to cut it to the right length as it should be flush with the outside of the handle casting.
Shaune509
Joe504
03-04-2021, 01:12 AM
Contacted CH4D. I'm getting 3 pins at $3.50 each :)
Sent from my SM-G955U using Tapatalk
Mk42gunner
03-04-2021, 11:18 PM
Since you'll have two spares, you will never need them. Until you lose them.
Robert
Joe504
03-05-2021, 02:19 AM
I was taught something really smart about parts like this. You get a small box, like and old film canister, and strap it to the press/tool/whatever, with hose clamps.
Parts stay with the press.
Sent from my SM-G955U using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.