Lyman 356637 hp devastator 124gr. mold

[phantom15]

Does anyone have a few of these boolits I can buy or maybe the mold itself?

Thanks

[45-70 fan]

Phantom...

I bought this mold quite a few months ago but have yet to cast any. I usually do my casting in the winter months in my garage when the weather is too crappy to be outside. But anyway, if you PM your info to me. When I get around to it, i'll email you to see if you are still in need of some. if you are just wanting a few to try i won't charge anything other than the ride. The alloy I use is coww with a little extra tin added for good fill out if needed. Being as these are hollow point I won't be water quenching them so rough guess of hardness would be somewhere around that 10-12 mark. I do hi-tek coat and lube. The lube is unnecessary with the hi-tek but I get absolutely no leading of barrels.

Let me know

Thanks!

[SteveM54]

45-70 fan,
Lyman 356637 hp devastator 124gr. mold
Sir, I just purchased the same mold when I ordered my Lee 4-20 pot. Haven't used either one as I'm still getting things set up. (I'm a newbie) Have you used your yet? If so, any tips/tricks would be appreciated.