JSH
12-24-2008, 08:43 AM
Any of you guys had any luck shooting 140+ boolits in one of these? I keep running across one in 30C every other month or so.
I have some load data for heavier than normal loads. I think this was for a TC, but swear some one here had given me some data a few years back. I looked through my folders and could only find some hand written notes and one small article.
I have been waiting on Ruger to chamber the 327 in the black hawk but I imagine it will have a 312 or so bore.
I would like to keep 308-309 bore, so as to be able to use my 30 caliber mould selection.
ven if I had to design a heavy LBT style and have a mould made I would give it a shot if there is the possibility it would fly.
BTW, this is an IHMSA project and it will have to fly out to 200M. After market sights are going to be a must as the Ruger sights I have seen, leave a bit to be desired. Sights will be the least of my worries.
Any hands on experiance would be appreciated.
Jeff
I have some load data for heavier than normal loads. I think this was for a TC, but swear some one here had given me some data a few years back. I looked through my folders and could only find some hand written notes and one small article.
I have been waiting on Ruger to chamber the 327 in the black hawk but I imagine it will have a 312 or so bore.
I would like to keep 308-309 bore, so as to be able to use my 30 caliber mould selection.
ven if I had to design a heavy LBT style and have a mould made I would give it a shot if there is the possibility it would fly.
BTW, this is an IHMSA project and it will have to fly out to 200M. After market sights are going to be a must as the Ruger sights I have seen, leave a bit to be desired. Sights will be the least of my worries.
Any hands on experiance would be appreciated.
Jeff