Top punch ?

[Ky-Dave]

Mold is Lee TL 356-95 RF. I realize it’s a tumble bullet, I’m only sizing on the 450. Will be powder coating them.
There is no top punch on the charts I’ve seen. Does any one know which one I need?
I’m picking up mold today and would like to get the punch while I’m there.
Thank you,
David

[C.F.Plinker]

Since that is a round-flat any wadcutter or semi-wadcutter top punch will work. Look for a 344. 495, or 495 top punch.

[Winger Ed.]

In a pinch, you can take one that is too wide, put a little dot of JB weld on it,
set it and your boolit (lightly oiled) in the sizer, pull the lever down snug, and it will make the right top punch.