View Full Version : Mp 432-640
Iwsbull
12-08-2020, 12:12 AM
I have looked and cannot find the dimensions on this boolit. I am trying to figure out if it will work in a Henry rifle or if it is a maybe. If anyone is running this or has some measurements I would really appreciate it. Also if it doesn’t, what other NOE or MP hollow point mold will work and what kind of accuracy and velocities are you getting.
Thanks
Mal Paso
12-08-2020, 03:54 PM
The nose is about .385" from the top of the crimp groove and the rim is quite thin if you use the large hollowpoint pin. The Hammer might be a better choice but it sold out.
The regular 432-640 has a meplat about .300". I couldn't find a drawing but evidently there was a short nose version 'cuz I found a drawing of it
sukivel
12-08-2020, 07:30 PM
.754 long
.307 meplat
.361 base to crimp groove
.060 hp rim (with large pin)
.169 lube groove to base
.075 lube groove width
Mine looks a little longer than the previous drawing.
https://uploads.tapatalk-cdn.com/20201208/09f60581f98e3db7328b508b4c93ce54.jpg
Sent from my iPhone using Tapatalk
Iwsbull
12-09-2020, 09:17 AM
Thank y’all.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.