H-Dies in Walnut Hill press?

[Darth-Vaj]

Will Corbin Mfg’s “H” dies work in Richard’s Walnut hill press?

[rbt5050]

no, you will need to go with corbin press made for H dies.

[Darth-Vaj]

no, you will need to go with corbin press made for H dies.

Thanks and you confirmed this by actually trying it?

[DDriller]

"H" dies are 1" x 12. Walnut Hill press is 7/8" x 14. You can take the bushing (1 1/2" x 12) out of the WH and have a special bushing made for the H dies.

[Darth-Vaj]

"H" dies are 1" x 12. Walnut Hill press is 7/8" x 14. You can take the bushing (1 1/2" x 12) out of the WH and have a special bushing made for the H dies.
My current bushing is the standard 7/8X14. Will the swage die fit in the press ram?

[DDriller]

with this adapter it will.
http://www.swagedies.com/mm5/merchant.mvc?Screen=PROD&Store_Code=CBST&Product_Code=WH-ADAPT&Category_Code=SDIES

[Faret]

with this adapter it will.
http://www.swagedies.com/mm5/merchant.mvc?Screen=PROD&Store_Code=CBST&Product_Code=WH-ADAPT&Category_Code=SDIES

Not even close 1" thread vs 7/8" thread. Can't fit a larger thread into a smaller one. You would need a CSP-1 press or the Hydraulic press which the dies were originally designed for.

[DDriller]

Not even close 1" thread vs 7/8" thread. Can't fit a larger thread into a smaller one. You would need a CSP-1 press or the Hydraulic press which the dies were originally designed for.

You are correct. That is for "S" dies.

[Darth-Vaj]

Thanks. Needed that info for sure beforr buying a used one.