Knockout bars

[kimoleto]

I need the sizes of the bars, can somebody measure them and share the data? (Corbin press I guss, I made the model on the forum). I understand there are 3 bars supplied, I cant find the sizes and have been guessing with good results but would like to have some better idea

[bullet maker 57]

They are .5, .75, 1in, and 1.5in. That is plus or minus a couple of thousands.

[kimoleto]

Thanks a lot, now I have some milling to do

[bullet maker 57]

Good luck! Should be an easy task.

[kimoleto]

I only have a mini mill, so I can do it but have to go slow and carefully

[Zbench]

I wouldnt spend too much time. I find that I'm often looking for just the right size when using my hand press. I'd get 1/4" square stock and just stack them to the size you need. More variability is better than less and no milling required. That's assuming the slot in your ram is at least 1/4" wide.

[kimoleto]

I got some scrap iron and just squared it, it was easy, cheap, looks nice and works