PDA

View Full Version : 6.5 Creedmoor subsonic load



Truthsabre
10-18-2020, 11:34 AM
Any thoughts or recommendations on a subsonic load for the 6.5 Creed? I want a heavy bullet (140 to 160 gr.) moving around 1000fps.

Larry Gibson
10-18-2020, 03:31 PM
Intended for a bolt gun as my recommendation will not function a gas gun. I developed one years ago in my 6.5-308. Used the 266469 (140 gr GC'd) cast soft (20-1 alloy) over Bullseye. Suggest you start at 4.5 gr and work up till the bullet hits 1050 fps +/-. No wad or filler needed though if a push feed action with plunger ejector I suggest drilling out the flash holes to avoid case shoulder set back after a very few firings.

Truthsabre
10-19-2020, 01:10 PM
Thanks a lot Larry. I was wanting to use Trail Boss but it's virtually impossible to find. Thanks again.

pacomdiver
10-22-2020, 06:16 PM
truth,
too bad your not in eastern PA, Sarco has at least 10 1lbers on the shelf and lots of other powders too