View Full Version : Scope Ring height recommendation for BFR 500JRH
My new BFR Bisley in 500JRH will be here in about a week. I plan on using the factory scope mount and setting up an Ultra Dot and a Leupold FXII 4x handgun scope in Leupold QRW2 rings. I would like to go ahead and order the rings so I will have them on hand. I already have the 4x Leupold in hand. What height should I order? Low or Medium?
Thanks for any assistance.
lar45
09-18-2020, 10:22 AM
Depending on how you load it, the 500 JRH can be abit of a handfull.
I don't have a 4x Leopold on hand to check for height, but I might suggest getting 2 sets of rings so that you can put 3 individual rings on the scope to make sure it stays where you put it.
I'm not sure if he has any left, but Fermin Garza made a run of Steel BFR front sights just for the 500 JRH.
https://i.imgur.com/BHsbCAY.jpg
https://singleactions.proboards.com/thread/22743/custom-steel-front-sight-group
http://www.lsstuff.com/pics/bfr/bfr-sights-01.jpg
http://www.lsstuff.com/pics/bfr/bfr-sights-02.jpg
269155
Leupold Low QRW2 work fine with the UltraDot and the FX II 4x
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.