Alox / JPW lubed .380 boolits

[Ohio Rusty]

These are the 356242's that I'm casting for my .380. The lube is Alox thinned a little with mineral spirits and JPW. It is one teaspoon of JPW to a teaspoon and a half of the Alox. The boolits are dry and ready to use. At this point, Do I just load as is or do I still need to lube the lube grooves with my normal bullet lube over top of the Alox/JPW coating ??

Ohio Rusty ><>

[Bookworm]

Just load them up. No need for additional lube. You have plenty on there now.

More than enough, actually, but it is what it is. Shoot em.

[Dusty Bannister]

"These are the 365242's that I'm casting for my .380. "

I hope that is a typo because a 365xxx would be for the 9MM Makarov. Perhaps you mean a 356242 which in the 90-95 grain weight is correct for the .380 ACP. Two very light coats is always preferred as it dries quicker and remains less tacky.

[Ohio Rusty]

Thanks Dusty ... corrected the 356242 typo.
Ohio Rusty ><>