Universal decapping die for small flash holes?

[Chuck Perry]

I need a universal decapper that is capable of handling Speer 357 SIG brass with the extra small .060 primer flash hole. Redding's will do so with an optional decap rod. Are there any other options out there?

Sent from my SM-N920V using Tapatalk

[nhyrum]

I used a Lee die. I had to take the pin out and basically sand it down I think you can buy a small flash home pin from somewhere

Sent from my SM-G975U using Tapatalk

[BigAlofPa.]

I use squirrel daddy pins.
https://www.squirreldaddy.com/Decapping-pin-s/336.htm

[djryan13]

I love this decapper:
https://fwarms.com/shop/
They have a small tip for it.

[rbt5050]

fw arms best decapper i have ever used, and i used them all.

[tomme boy]

Hornady uses the small diameter replaceable pins.

[Chuck Perry]

FW Arms looks nice, but it's going to cost me around $75 for the die and extra decapper for the small flash holes. Buy once cry once? I have an email out to Squirrel Daddy asking if they have Lee replacement pins compatible with .060 flash holes.

[Chuck Perry]

Heard back from Squirrel Daddy. They don't offer a rod for .060 flash holes.

Sent from my SM-N920V using Tapatalk

[nhyrum]

Mighty armory has small flash hole pins.

https://www.mightyarmory.com/collections/pins-and-shafts/products/copy-of-decapping-pin-070-standard-or-055-lapua-heat-treated-and-tempered?variant=5097667788841

Sent from my SM-G975U using Tapatalk

[higgins]

I needed a small decapping pin for some Igman 6.5x55 brass. I had some spare pins so I chucked on in my drill and polished it down with 400 sandpaper. Thankfully the flash holes were well centered so I wasn't bumping my thinner pin into the case. Don't forget to put the smaller pin in a marked envelope.

[nhyrum]

I used my small pin for just about everything. Even my 300 rum. I think really the only place I'd be carful is military cartridges that tend to have sealed and/or crimped primers. It will be more fragile if you turn your own down like I did. But the mighty armory one should be better than the standard Lee pin

Sent from my SM-G975U using Tapatalk

[Vdubman27]

Chuck perry I have. Fw arms but not the small hole pin but what I can tell you is it will blast right through berdan brass with zero pin damage so if the small pin is as I expect the same quality you are correct in buy once

[Vdubman27]

I love this decapper:
https://fwarms.com/shop/
They have a small tip for it.

Yea the fwarms is a great choice