PDA

View Full Version : New to forum. Getting some loads ready for a M1903



M1fuzz
06-01-2020, 04:17 AM
Hello. Long time lurker now a new member. Anyway, I shot cast for several years then got away from it shooting mainly jacketed. In my Springfield M1903 I changed over to. CMP load. 110 grain Sierra Varmiter over 47 grains of IMR3031. It shot well and had less recoil than 150-168 grain loads.

Now, I have decided to come back to where I started. Cleaned the bore of copper and am ready to go. I am using my old stand by 311299 sized to .311. Federal Gold Medal match brass and WLR primers. I have used 5744 and IMR4227 in that rifle before I am going to try testing groups using IMR4227 with 16,17,&18 grains. Does anyone for see any problems with that? I am not using any Dacron filler. You think I need to tip the muzzle back?

Hope to hear some ideas back and look forward to being here. Thank you.

NC_JEFF
06-01-2020, 06:26 AM
Welcome M1, I was shooting the 311299 just yesterday in a Win model 70 30 -06. I'm don't have the experience to comment on your load just wanted to welcome you in.

RU shooter
06-01-2020, 08:14 AM
I've used 2400 in that range before and never had positioning issues can't speak of 4227 try a few 10 rd groups each way will tell the story

BigAlofPa.
06-01-2020, 08:32 AM
Hello and welcome. I run 13 grains of red dot. In cast loads for 30.06. It has worked out well.

jugulater
06-01-2020, 11:44 AM
i’ve used 17grn-20grn of IMR4227 in 8x50R and 8x56R Mannlicher without issues, no barrel tipping or inconsistent ignition. it’s a significantly different case from 30-06, but the internal volume is similar, so i would expect to see similar results with ignition.

Welcome to the Forum BTW.

M1fuzz
06-01-2020, 06:49 PM
Thanks for the welcome and the answers.

ShooterAZ
06-02-2020, 06:00 PM
The 311299 shoots OK in my 1903, but the RCBS 30-165 SIL shoots like a house afire with 20.5 grains of 2400. A 310 sizer is what I use for this one. No filler needed with this load either.

M1fuzz
06-02-2020, 07:08 PM
Roger. Thanks.

Bad Ass Wallace
06-02-2020, 11:37 PM
My 03 Springfield is fitted with a 4 groove barrel (08/44) and a 12X Leupold scope. Using the Lyman 311284 sized to 0.310" ahead of 31.5gn 3031 (1740fps) I printed this 10 shot group under MOA off a benchrest.

https://i.imgur.com/SabiU6Dm.jpg

https://i.imgur.com/4aMC0cKm.jpg

Larry Gibson
06-03-2020, 07:07 PM
Two sighers and 20 shots "for record" of 30 CXB (NOE 310-165-FN) over 20 gr of 2400 w/dacron filler at 100 yards. Rifle is M1903A1 with RA-43 four groove barrel built into National Match Type II configuration.

263125

263126

M1fuzz
06-05-2020, 03:05 AM
Nice shooting by both of you.