Mold for Sig P220 10mm

[AlanF]

Looking for mold recommendations for my Sig P220 10mm. Wanting to hunt with it so I am thinking 180gr-200gr with as much meplat as will cycle reliably. I ladle pour and figure a 3-cavity is probably the most I can do well. Appreciate your advice.

[maxreloader]

The RCBS 180 gr rnfp mold/boolits work great for me. I picked up an outhouse load of them when a local casting company went belly-up. All the retailers ran, it was weird. This was a few years ago. They function in my Glock 20 and 29 (with replacement barrels) flawlessly.

[shooting on a shoestring]

I’ve used the Lee 175 Truncated Cone. Typical Lee, a little out of round at the parting lines and had to “Beagle” it up to size 0.403. But it has a good meplat and runs fine through my 220.

My favorite is Accurate 40-165A. I run that boolit in the P220, XDm and SR1911 with enough Blue Dot to get 1350-1400 (depending on gun). I asked for 0.403” with my alloy (96 Pb, 2 Sn, 2 Sb) and got it! Also as round as I can measure. The Accurate mold is a pleasure to use and is SO WORTH the cost to me. The Lee hasn’t seen service since the Accurate arrived.

I don’t hunt deer (other than I try see them before they jump in front of my pickup). So can’t speak on how that boolit takes deer compared to other boolits.

[osteodoc08]

NOE 198gr WFN shoots well out of my P220 Hunter model in 10mm.

[AlanF]

Thanks guys. I will looking into a mold very similar to the NOE 198gr WFN. I can't imagine it would not do anything a 10mm should be doing.

[COOLBARRELBILL]

Try the LBT 200gr WFN. You can buy some from Montana Bullet Works to see if you like them. They feed reliably and I have killed a few hogs with them over 800X.

[Jtarm]

Try the LBT 200gr WFN. You can buy some from Montana Bullet Works to see if you like them. They feed reliably and I have killed a few hogs with them over 800X.

What gun?

[Chuck Perry]

My favorite is Accurate 40-165A. I run that boolit in the P220, XDm and SR1911 with enough Blue Dot to get 1350-1400 (depending on gun).

That's a thumper!

[COOLBARRELBILL]

What gun?

Glock 20 and 40 both have KKM barrels. I use an OAL of 1.235

[Outer Rondacker]

Glock 29 KKM barrel Lee 175 TC mold PC HF Red. Weight 180g on final bullet not going to share my power change but shot well. I would have shot a bear with that round if need had been. A good friend of mine is bush piloting in Alaska so I sent it with him just in case. Perhaps I will get the gun back some day.