Is it just me?

[PbHurler]

I can't seem to get onto MP Molds website, operation times out.
Anyone else getting this? or could it be on my end.

Thanks

[Jeff Michel]

I was on his sight two days ago, did not have any problems.

[Mr Peabody]

Watching the TV it looks like Europe closed up

[RKJ]

I just tried it and it works. You might want to reset your router/modem.

[PbHurler]

I'm at work, but the diagnostic says I'm configured correctly, but the device or resource (www.mp-molds.com) is not responding.

I'll try again once I'm back home......

Thank you

[Ickisrulz]

I just clicked your link to MP Molds and got right in.

[gwpercle]

I'm at work, but the diagnostic says I'm configured correctly, but the device or resource (www.mp-molds.com) is not responding.

I'll try again once I'm back home......

Thank you

I clicked on your posted link , it took me to the site and opened .. connected .. quickley , a matter of seconds . I'm using a desktop PC . When my Desktop PC is slow to connect or will not connect , I turn it and the Wi-Fi off (disconnect the power cord ) and shut it all down for a while . Later turn it all back on and restart the PC , usually that clears the no/slow connecting thing .
Gary

[tomme boy]

It has been messed up for a while. You are not the only one with the problem. It will lock up. Your cursor baar will be jumping up and down while it locks up. Usually you can refresh the page and it will work for a little bit again. I just don't go to it anymore.

[PbHurler]

Works fine from home, must be a "security thing" from work

Thanks guys....

( it did cost me a few $ though) :grin: