Fly
03-01-2020, 07:08 PM
I bought a Taurus G2c in 9mm. Gun has performed flawless, with factory ammo, with over 400 rounds. The only two semi auto other than
this one I have are a 380 & 40 SW that I have loaded with my cast bullets with lee molds & dies, No problem. I loaded 4 rounds of my cast 125 gn lead
Hi-tec coated & 3.8 Titegroup. I tested the 4 rounds while a go & my receiver is locking up just short of complete closing. It is on of those deals
where I need tp bump the rear to get it to chamber completely. I,m guessing bullet length. I set my bullets at 1.156. Lee manual shows min oal 1.42.
Could it be a little long for this bullet & charge?
Fly
this one I have are a 380 & 40 SW that I have loaded with my cast bullets with lee molds & dies, No problem. I loaded 4 rounds of my cast 125 gn lead
Hi-tec coated & 3.8 Titegroup. I tested the 4 rounds while a go & my receiver is locking up just short of complete closing. It is on of those deals
where I need tp bump the rear to get it to chamber completely. I,m guessing bullet length. I set my bullets at 1.156. Lee manual shows min oal 1.42.
Could it be a little long for this bullet & charge?
Fly