45acp
02-21-2020, 02:41 PM
Hi.
Today when i was going to cast some i got some boolits that had some strange faults.
I have recently melt down some ww and i wonder if there might have been some zinc weights in there?
I hope this might been caused from another reason.
Not all bullets, maybe 30% has some faults.
No wrinkles that i understand is common with zinc contamination.
I had the same temperature as i use to (arond 703F, pid controlled).
The only thing that i can think about is that i heated the mold a bit hotter before casting, (and maybe dropping them a liitle faster than usual.
What do u think? Will i need to dump my muffins, around 180lb?
https://imgur.com/nsz3pIY
https://imgur.com/cD0yWkX
257268
Today when i was going to cast some i got some boolits that had some strange faults.
I have recently melt down some ww and i wonder if there might have been some zinc weights in there?
I hope this might been caused from another reason.
Not all bullets, maybe 30% has some faults.
No wrinkles that i understand is common with zinc contamination.
I had the same temperature as i use to (arond 703F, pid controlled).
The only thing that i can think about is that i heated the mold a bit hotter before casting, (and maybe dropping them a liitle faster than usual.
What do u think? Will i need to dump my muffins, around 180lb?
https://imgur.com/nsz3pIY
https://imgur.com/cD0yWkX
257268