Noe 310-247 FN

[pacomdiver]

just got one, anyone have a 300 B/O load for it ? im gonna PC it and use LC converted brass

[pacomdiver]

nobody?

[Hamish]

Bottom end book loads will get you started.

255006

[adcoch1]

As Hamish stated, just start on the bottom end of the closest bullet and keep in mind volume of the case with the bullet seated. Some powders will fill out the case better than others. I don't have any direct experience with that boolit but I am tagging along because I am also looking at that mold.

[Hamish]

I'm very surprised someone has'nt posted about that particular mold in the BO. The heaviest I shoot is a 200gr LGGC at a comfortable 15.7gr of Reloder 7. Have paid attention to this thread as I've been thinking of PC'ing a plain based TL309-230R in my BO's. If I liked it, was going to try the NOE.

[SdRemmy]

I use this bullet in 300 blk out. I believe it’s 10 gr aa1680

[odfairfaxsub]

I use it both plain based and gas checked w 10.5 gr imr 4198

[pacomdiver]

ive been using it (plain base) powder coated with 8.0 g H110 in LC cases and CCI primers. it cycles my 10.5 B/O and locks back on last round. ive been experimenting with it in 308 and Trailboss powder with some good results