DonH
12-05-2019, 06:16 PM
I recently bought a Finney Featherweight Deluxe (side safety) to install on a M1916 Mauser action. The trigger is #303 which Finney specs for M95, M96 Mausers. Installed on the action the sear projects above the top of the square slot for the cocking piece. When the bolt is cycled the striker cocks but pulling the trigger does not release the striker.
My VZ 24 (M98) has a Finney trigger so I pulled the bolt for a look see. The sear projection is a fraction as high as the new one on the 1916. On a whim I removed the trigger from the VZ 24 to try it on the 1916. The trigger for the M98 fit on the M1916 and worked perfectly. So it seems I need the safety version of the M98 trigger.
I wondered if anyone else here has encountered this?
BTW, after describing this to Finney I was told by a tech that I might cut metal off the top of the sear.
My VZ 24 (M98) has a Finney trigger so I pulled the bolt for a look see. The sear projection is a fraction as high as the new one on the 1916. On a whim I removed the trigger from the VZ 24 to try it on the 1916. The trigger for the M98 fit on the M1916 and worked perfectly. So it seems I need the safety version of the M98 trigger.
I wondered if anyone else here has encountered this?
BTW, after describing this to Finney I was told by a tech that I might cut metal off the top of the sear.