Forester co axe without stand ?

[zymguy]

I never decap on my press. I decap in a comfy chair with a hand tool. Is there any other reason I would want a stand ?


Sent from my iPhone using Tapatalk

[JimB..]

I have mine at bench height, am thinking about raising it up a bit. I load standing up.

[hornetman]

I have two co-ax presses, both mounted on elevated stands with quick-change plates from inline fabrication. Even though my bench is 38inches high I find the stands make all operations easier from either a standing position or while seated on a tall stool. Their offset roller handles are also a great accessory.

[mdi]

Do you mean an after market press stand that elevates the press above the bench? I have a "normal" height bench, never measured the height, and have been using my Co-Ax for 4 years with no need to raise it. The press is mounted on the bench so the primer catcher and op rods extend below the bench top, as designed, and with a few thousand rounds have never needed anything else...