pakmc
04-20-2019, 07:36 PM
I got my new Spiller and burr in Friday and after searching for FFFG black powder(and not finding any around here, I went with Hodgdons triple 7. it's a brass frame with a 6 and 1/2 inch blued barrel. my Flask with filled with FFG powder and I tried that first. the book says that .22 gr's of black is the max. after putting in .22 gr's of FFG and a fiber wad and a tab of grease the ball stuck out of the cylinder to where I had to cut off the top of the ball with my knift. the load was so weak that most of us could spit father than that! I cut the charge back to 15 gr's of FFG and that was worse.(and no I didn't hit the steel plate at 10 yards that I was aiming at.) In desperation I went to the hodgdon triple 7. with 15gr's of triple 7, and a paper target I found that the ball was hitting the paper about 10 inches high at 10 yards. and I finally got all 6 plates with 6 shots. I used number 10 and 11 caps. the 10s had to be pressed hard on the nipples and the 11's had to be pinched to stay on the nipple. it was easier to load the cylinder with powder and wad with the cylinder out of the gun,(My loading proceadure was not a good one for this gun. I had to pour the powder into a variable charger first and then pour the powder in the variable charger, into the cylinder.( it was a big pain in the ordure orffice.)
the good news is the triple 7 cleans up nice. one patch down the barrel and it was clean enough. and there wasn't much left in the cylinders, I'll be waiting to see if it starts to rust! and yes, I put the powder in the cylinder first then a fiber wad next, with a drop of lube. then the ball. but 15gr's of triple 7 felt like a good charge and it knocked the plates down.(the plates are 8 inch dia. about 5/8 inch thick. it looks like I got more trash from the primers on the frame then from the powder. it was a good day at the range, sunny and about 80 degrees
the good news is the triple 7 cleans up nice. one patch down the barrel and it was clean enough. and there wasn't much left in the cylinders, I'll be waiting to see if it starts to rust! and yes, I put the powder in the cylinder first then a fiber wad next, with a drop of lube. then the ball. but 15gr's of triple 7 felt like a good charge and it knocked the plates down.(the plates are 8 inch dia. about 5/8 inch thick. it looks like I got more trash from the primers on the frame then from the powder. it was a good day at the range, sunny and about 80 degrees